700mm 415v 2500w replacement infrared halogen lamp

700mm 415v 2500w replacement infrared halogen lamp

Introduction

We built this infrared halogen lamp to be a straight-up, drop-in replacement for industrial heating systems—the kind where space is at a premium and you need heat, fast. It’s 700mm long, runs on 415V, and packs 2500W of power. If your setup needs a heat source that’s reliable and quick without forcing you to redesign the whole heater housing, this one is made to just plug in and get to work.

Power, Voltage, and Size—Why It All Matters

That 2500W rating in a 700mm frame wasn’t an accident. It was a choice to concentrate output into a long, narrow footprint so you can match heating zones on conveyors, shrink tunnels, and thermoforming frames without fighting the geometry. And the 415V? That lowers the current for the same power, which means you can use smaller conductors and makes wiring in 3-phase industrial panels a lot cleaner. Here’s the catch: it’s a high-voltage lamp. So your control gear, insulation, and safety clearances have to be up to the 415V requirement. And the fixture needs to handle the heat load without letting nearby components cook.

What’s Inside: Halogen, Quartz, and a Smart Connector

Infrared halogen lamps lean on a quartz envelope because it can take the heat and lets IR pass through cleanly. The halogen cycle keeps the filament stable by sending evaporated tungsten back where it belongs—so output stays steady over the lamp’s life, and the envelope stays clearer. Many versions add a coating to tune the spectral output and keep the quartz protected from contamination. And the R7s connector? It’s the standard for a reason: it gives secure, two-end support that can handle thermal expansion and the vibration that comes with industrial equipment.

Where It Shines—and What It Feels Like to Use

This lamp is for the moments when you need focused, radiant heat fast—drying, curing, preheating, plastic processing. The 700mm length makes alignment in long, narrow heaters straightforward, and the 415V/2500W combo gives you serious heat density without hauling around massive current. Installation is simple, as long as you do the basics: verify voltage, check your clearances, and wire it as the drop-in replacement it was designed to be. Just plan for airflow or a thoughtful reflector setup—when you pack this much power into a tight space, managing heat is part of the job.