1300w circular halogen infrared heating lamp

May 6, 2026

Meet the 1300W circular halogen infrared heating lamp—built for those tight spots on the factory floor where you need heat, and you need it fast. We designed it to throw concentrated energy right where you need it, so you can get instant, controllable heat without turning the whole work cell into a sauna. Here’s the thing about that 1300W punch: it delivers serious heat density, which means your target—like PET preforms, plastic films, or small metal bits—heats up quickly. Match the lamp to the job, and you avoid sluggish cycles or wasted energy. It’s just the right power for the task. And the circular shape? It focuses the beam into a clean, predictable hot zone. This isn’t some wide, ambient heater. It’s a targeted tool, and that makes shielding and aiming a whole lot easier. Inside, the halogen cycle keeps the filament stable by sending evaporated tungsten right back where it belongs. That means consistent output over the life of the lamp, even with frequent on/off cycles. No premature dimming. No surprises. The quartz envelope is there for a reason. It handles the high filament temperature and stays clear for infrared energy to pass through. Plus, it stands up to rapid heat-up and cool-down—the kind of thermal shock you see on a busy production line. We went with an R7s connector because it’s secure, aligned, and simple. Slide the lamp in, lock it down, and you’ve got a solid connection. It cuts down on field headaches from loose terminals or misalignment, and it makes replacement during maintenance a straightforward swap. On the job, this lamp shines at preheating PET preforms, softening thermoplastic sheets, curing coatings on small parts, and localized drying. The infrared heat hits the surface directly, so you get shorter cycle times than you would with convection methods. Now, the trade-off: high power density means you need to plan for proper mounting and thermal management. This lamp runs hot, so give it enough clearance, add reflectors, and make sure airflow is sorted around the fixture. Get that right, and you’ll have reliable performance with minimal downtime.